Steps:
1. Mount the 120-volt transformer to the house wall, preferably behind a shrub to make the transformer less noticeable.
2. Stretch the low-voltage cable from the transformer to each light fixture.
3. Install a ground stake onto the stem (shaft) of each light fixture.
4. Strip the ends of the cable and fixture wires, then twist them together to make two connections.
5. Slide brass connectors over each wire connection, then tighten the connector with a hex-key wrench.
6. To ensure watertight connections, slip heat-treated tubing over the brass connectors, then use a propane torch to seal the tubing.
7. Push the sealed wire connections up into the hollow stem of the light fixture.
8. Firmly push the light fixture's stake deep into the ground.
9. Use square-blade shovel to cut a narrow trench from one light fixture to the next.
10. Leave an extra 2 feet of cable at each fixture. Push the cable down into the trench.
11. Install lamps (light bulbs) into each fixture and attach the shades.
12. Connect the cable to the terminals inside the transformer, then screw the faceplate onto the transformer.
Plug the transformer into a 120-volt receptacle.
13. Flip on the switch and check to ensure that each fixture lights up.